________________________________________________________________________________________
| Home / Car Engines / Toyota Engines / Toyota 2ZZ-GE |
Toyota 2ZZ-GE Troubleshooting
| Engine will not start or hard to start |
No gasoline in tank - Fill it up.
Incorrect fuel grade - Use quality gasoline.
Air trapped in fuel system - Bleed air.
Spark plug wire is disconnected or loose - Inspect the spark plug wire connection, replace or repair.
Damaged spark plug - Replace spark plug.
Ignition failure - Test ignition and replace failed parts.
Fuel filter is plugged - Change fuel filter.
Clogged fuel lines - Fuel lines need to be cleaned.
Dirty or damaged fuel pump - Clean or change fuel pump.
Fuel injectors are damaged or dirty - Clean or replace fuel injectors.
Low cylinder compression - Check cylinder block and replace worn parts.
| Engine runs roughly |
Ignition failure - Check ignition system and replace faulty parts.
Air filter is blocked - Change or service air filter.
Defective spark plug - Change spark plug as required.
Clogged or damaged fuel pump - Clean or replace fuel pump.
Valve clearance is not correct - Adjust valve clearance.
Improper ignition timing - Ignition timing needs to be set properly.
Wrong adjustment of low idle speed - Correct idle settings.
| Engine stalls after starting |
Spark plug is damaged - Replace spark plug.
Clogged or defective fuel injectors - Check fuel injectors and replace if necessary.
Ignition coil is damaged - Change ignition coil as required.
Loose or worn valve springs - Replace valve springs.
Valves sticking - Valves need to be cleaned.
| Engine overheated |
Engine oil insufficient - Check and refill engine oil.
Engine overloaded - Reduce the load.
Fuel injectors are clogged - Test fuel injectors and service if necessary.
Incorrect ignition timing - Set the ignition timing properly.
Valve setting is improper - Adjust valves correctly.
Defective radiator cap or clogged radiator core - Clean radiator or install new cap.
Coolant level is low - Fill radiator to proper level and check components for faults.
Damaged thermostat - Change thermostat.
Faulty water pump - Replace water pump.
| Engine noise or knocking |
Low octane fuel - Use proper fuel.
Engine overload - Load reducing is recommended.
Not enough engine oil - Checking oil level and add if necessary.
Incorrect low idle setting - Adjust the low idle speed.
Dirty or defective fuel pump - Clean or install new fuel pump.
Crankshaft or main bearings are worn out - Have bearings or crankshaft replaced.
Improper valve clearance - Need to adjust valve clearance.
Worn piston rings or cylinder bore - Replace faulty components.
| Loss of engine power |
Clogged or defective fuel injectors - Inspect fuel injectors and change as required.
Clogged air filter - Service or replace air filter.
Clogged or damaged fuel pump - Check fuel pump and replace if necessary.
Ignition system is defective - Check ignition system and replace faulty parts.
Cylinder head gasket is worn - Change cylinder head gasket.
Valves are burned or stuck - Replace or clean valves.
Cylinder block parts are worn out - Change defective components.
Plugged oil filter - Change or service oil filter.
| Engine using too much gasoline |
Clogged air filter - Clean or replace air filter.
Fuel injectors are clogged or faulty - Clean or change fuel injectors.
Spark plug is loose or faulty - Spark plug need to be tightened or replaced.
Ignition timing is incorrect - Set the ignition timing correctly.
Valves are worn, stuck, or burned - Clean or replace valves.
Sleeve, piston, or rings are damaged - Replace faulty parts.
Improper valve clearance - Adjust to proper valve clearance.
Weak cylinder compression - Inspect cylinder block and change worn parts.
| Excessive engine oil consumption |
Seals or gaskets are defective - To repair leaks, replace worn parts.
Valve guides or stems are damaged - Install new valves.
Stuck or defective piston rings - Have piston rings replaced.
Damaged piston or cylinder liner - Check piston and liner, change as required.
| Engine backfires |
Clogged fuel injectors - Check fuel injectors and clean if necessary.
Dirt in the fuel lines - Clean fuel system lines.
Improper ignition timing - Set the ignition timing correctly.
Improper valve setting - Valves needs to be adjusted properly.
Air filter is dirty - Replace or clean air filter.
________________________________________________________________________________________
________________________________________________________________________________________
| Engines Technical Specifications |