________________________________________________________________________________________
| Home / Car Engines / BMW Engines / BMW M40B16 |
BMW M40B16 Troubleshooting
| Engine starts up hard or will not start |
Empty gas tank - Fill gasoline up.
Improper fuel grade - Change fuel.
Air in fuel tank - Bleed fuel tank.
Spark plug wire connection are damaged - Inspect spark plug wiring connection, change or repair.
Spark plug is defective - Change spark plug.
Defective ignition system - Inspect ignition system and change failed components.
Dirty fuel filter - Replace fuel filter.
Clogged fuel lines - Fuel lines need to be cleaned.
Fuel pump is clogged or faulty - Clean or replace fuel pump.
Dirty or faulty fuel injectors - Service or replace fuel injectors.
Engine has low compression - Check cylinder block and replace defective parts.
| Engine runs roughly |
Defective ignition system - Check ignition and replace faulty components.
Air filter element is plugged - Clean or replace air filter.
Spark plug is defective - Change spark plug as required.
Dirty or damaged fuel pump - Test fuel pump and replace if necessary.
Valve clearance is not correct - Adjustment procedure required.
Ignition timing is wrong - Ignition timing needs to be set properly.
Too low idle RPM - Adjust idle speed.
| Engine starts and stops |
Damaged spark plug - Install new spark plug.
Clogged or damaged fuel injectors - Test fuel injectors and replace if necessary.
Defective ignition coil - Ignition coil must be replaced.
Loose or broken valve springs - Change valve springs.
Valves are stuck - Valves must be cleaned.
| Engine overheated |
Low engine oil level - Check oil level and add oil as required.
Engine is under excessive load - Reduce the load.
Fuel injectors are clogged - Test fuel injectors and service if necessary.
Ignition timing is wrong - Adjust ignition timing correctly.
Wrong valve setting - Set the valves correctly.
Clogged radiator core or damaged radiator cap - Install new cap or clean radiator.
Low engine coolant - Fill radiator to proper level and check components for faults.
Thermostat failure - Replace thermostat.
Damaged water pump - Water pump need to be replaced.
| Abnormal engine knocking or noise |
Low octane fuel - Use proper fuel.
Engine overloaded - Load reducing required.
Insufficient engine oil - Check and refill engine oil.
Too low idle RPM - Test and adjust.
Dirty or faulty fuel pump - Service or change fuel pump.
Crankshaft or main bearings failure - Change or repair worn components.
Incorrect valve clearance - Check and adjust.
Cylinder bore or piston rings are worn - Replace faulty parts.
| Loss of engine power |
Fuel injectors are dirty or defective - Check fuel injectors and change if required.
Air filter is blocked - Change or service air filter.
Dirty or faulty fuel pump - Check fuel pump and replace if necessary.
Defective ignition system - Inspect ignition system and change failed components.
Cylinder head gasket is defective - Replace cylinder head gasket.
Valves are stuck or burned - Clean or change valves.
Faulty cylinder block parts - Defective parts need to be replaced.
Oil filter element is clogged - Service or replace oil filter.
| High fuel consumption |
Air filter element is clogged - Service or replace air filter.
Clogged or damaged fuel injectors - Test fuel injectors and change if necessary.
Defective or loose spark plug - Spark plug need to be replaced or tightened.
Ignition timing is incorrect - Adjust ignition timing as required.
Valves are stuck, worn, or burned - Service or change valves.
Worn piston, rings, or sleeve - Replace faulty parts as required.
Excessive valve clearance - Need to adjust valve clearance.
Poor compression - Inspect and replace wear parts.
| Excessive engine oil consumption |
Worn gaskets or seals - Replace to repair leaks.
Valve stems or guides are damaged - Need to replace the valves.
Worn or broken piston rings - Replace piston rings.
Piston or cylinder liner is damaged - Check liner and piston, change as required.
| Engine backfires |
Fuel injectors are clogged - Clean or change fuel injectors.
Fuel lines are clogged - Clean fuel system lines.
Ignition timing is incorrect - Adjust ignition timing as required.
Valve setting is improper - Valves needs to be adjusted properly.
Dirty air filter element - Replace or service air filter.
________________________________________________________________________________________
________________________________________________________________________________________
| Engines Technical Specifications |