________________________________________________________________________________________
| Home / Car Engines / BMW Engines / BMW M43B18 |
BMW M43B18 Troubleshooting
| Engine will not start or difficult to start |
Gas tank is empty - Add fuel.
Improper fuel grade - Use correct fuel grade.
Dirty fuel system - Check and clean.
Spark plug wire connection are damaged - Check the spark plug wire connection, repair or replace.
Spark plug is damaged - Change spark plug.
Ignition system is defective - Test ignition and replace failed parts.
Clogged fuel filter - Fuel filter needs changing.
Restricted fuel lines - Service fuel lines.
Clogged or defective fuel pump - Check fuel pump and replace if necessary.
Clogged or defective fuel injectors - Inspect fuel injectors and change as required.
Engine has bad compression - Check cylinder block and change wear parts.
| Irregular engine running |
Defective ignition system - Inspect ignition system and change failed components.
Plugged air filter - Clean or replace air filter.
Defective spark plug - Replace spark plug.
Clogged or defective fuel pump - Check fuel pump and change if required.
Excessive valve clearance - Adjustment procedure required.
Bad ignition timing - Adjust ignition timing correctly.
Improperly adjusted low idle speed - Adjust idling as required.
| Engine starts and stalls suddenly |
Spark plug is faulty - Replace spark plug.
Dirty or faulty fuel injectors - Clean or replace fuel injectors.
Ignition coil is not working - Install a new ignition coil.
Broken or bad valve springs - Change valve springs.
Valves are stuck - Service the valves.
| Engine keeps overheating |
Engine oil level is insufficient - Add oil to the engine crankcase.
Engine overloaded - Load reducing is recommended.
Fuel injectors are clogged - Need to clean fuel injectors.
Ignition timing is incorrect - Adjust ignition timing as required.
Improper valve setting - Set the valves properly.
Damaged radiator cap or dirty radiator core - Replace cap or clean radiator.
Engine has a lack of coolant - Add coolant fluid and inspect the cooling system for leaks.
Thermostat is defective - Change thermostat.
Water pump failure - Replace water pump.
| Engine knocking or noise |
Stale gasoline - Use correct gasoline.
Engine overload - Load reducing is recommended.
Engine oil level is low - Check and refill engine oil.
Low idle speed set incorrectly - Adjustment required.
Clogged or defective fuel pump - Test fuel pump and replace if necessary.
Crankshaft or main bearings failure - Have bearings or crankshaft replaced.
Valve clearance is improper - Adjust valve clearance.
Piston rings or cylinder bore are damaged - Replace defective parts.
| Loss of engine power |
Dirty or defective fuel injectors - Check fuel injectors and change if required.
Plugged air filter - Replace or clean air filter.
Clogged or damaged fuel pump - Test fuel pump and replace if necessary.
Defective ignition system - Check ignition and replace faulty components.
Damaged cylinder-head gasket - Cylinder-head gasket replacement required.
Burned or stuck valves - Clean or replace valves.
Faulty cylinder block components - Replace defective parts as required.
Clogged oil filter - Change or service oil filter.
| Engine uses too much fuel |
Plugged air filter - Replace or service air filter.
Fuel injectors are clogged or faulty - Clean or replace fuel injectors.
Loose or defective spark plug - Re-tighten or replace spark plug.
Ignition timing is wrong - Ignition timing needs to be adjusted correctly.
Stuck, worn, or burned valves - Clean or replace valves.
Worn rings, piston, or sleeve - Change faulty components.
Valve clearance is improper - Adjust valve clearance.
Low engine compression - Inspect cylinder block and change defective components.
| Excessive engine oil consumption |
Damaged gaskets or seals - Replace worn parts to avoid leaks.
Worn valve stems and valve guides - Replace defective valves.
Seized or wear piston rings - Install new piston rings.
Scuffed cylinder liner or piston - Check liner and piston, change as required.
| Engine backfires |
Fuel injectors are clogged - Clean or change fuel injectors.
Fuel lines are dirty - Fuel lines must be clean.
Bad ignition timing - Adjust ignition timing as required.
Incorrect valve setting - Set the valves correctly.
Air filter is dirty - Clean or replace air filter.
________________________________________________________________________________________
________________________________________________________________________________________
| Engines Technical Specifications |