________________________________________________________________________________________
| Home / Car Engines / BMW Engines / BMW M44B19 |
BMW M44B19 Troubleshooting
| Engine difficult to start or won't start |
No fuel in fuel tank - Add gasoline.
Low-quality gasoline - Change gasoline.
Dirty fuel system - Check and clean.
Defective spark plug wire connection - Inspect the spark plug wire connection, replace or repair.
Spark plug is defective - Change spark plug as required.
Ignition system failure - Test ignition and replace failed parts.
Fuel filter is plugged - Install new filter.
Dirt in the fuel lines - Fuel lines need to be cleaned.
Fuel pump is dirty or defective - Test fuel pump and replace if necessary.
Clogged or damaged fuel injectors - Clean or replace fuel injectors.
Engine has bad compression - Check cylinder block and change wear parts.
| Irregular engine running |
Ignition failure - Inspect ignition system and change faulty parts.
Plugged air filter - Service or change air filter.
Faulty spark plug - Spark plug need to be replaced.
Clogged or damaged fuel pump - Test fuel pump and replace if necessary.
Valve clearance is wrong - Adjust valve clearance according to specifications.
Wrong ignition timing - Adjust ignition timing correctly.
Incorrectly adjusted low idle speed - Adjustment required.
| Engine starts but immediately stops |
Damaged spark plug - Replace spark plug.
Clogged or defective fuel injectors - Service or replace fuel injectors.
Ignition coil is damaged - Ignition coil should be replaced.
Loose or worn valve springs - New valve springs need to be installed.
Valves sticking - Service the valves.
| Engine is overheated |
Engine oil level low - Add oil to the engine crankcase.
Engine is overloaded - Reduce load.
Dirty fuel injectors - Inspect fuel injectors and service as required.
Ignition timing is wrong - Set the ignition timing correctly.
Incorrect valve setting - Valves needs to be adjusted properly.
Clogged radiator core or leaking radiator cap - Clean radiator or replace cap.
Coolant level is low - The cooling system needs to be refilled and checked for faults.
Defective thermostat - Change thermostat as required.
Damaged water pump - Water pump need to be replaced.
| Engine noises or knocks |
Low octane gasoline - Use proper fuel.
Engine overload - Reduce engine load.
Engine oil insufficient - Add oil to the engine crankcase.
Incorrectly set low idle speed - Correct idle adjustment.
Dirty or defective fuel pump - Service or change fuel pump.
Main bearings or crankshaft are worn out - Change defective components as required.
Valve clearance is improper - Need to adjust valve clearance.
Damaged piston rings or cylinder bore - Replace defective components.
| Engine power loss |
Fuel injectors are damaged or dirty - Service or replace fuel injectors.
Dirty air filter element - Clean or change air filter.
Fuel pump is defective or dirty - Clean or install new fuel pump.
Ignition failure - Check ignition system and replace faulty parts.
Damaged cylinder-head gasket - Replace the gasket as required.
Stuck or burned valves - Change or service valves.
Faulty cylinder block parts - Change defective parts.
Oil filter is dirty - Service or change oil filter.
| High fuel consumption |
Clogged air filter - Service or change air filter.
Clogged or defective fuel injectors - Inspect fuel injectors and change as required.
Defective or loose spark plug - Re-tighten or replace spark plug.
Ignition timing is incorrect - Adjust ignition timing as required.
Valves are stuck, worn, or burned - Change or service valves.
Worn sleeve, piston, or rings - Change defective components.
Valve clearance is not correct - Adjust to proper valve clearance.
Poor cylinder compression - Check cylinder block and change worn parts.
| Excessive oil consumption |
Damaged seals or gaskets - Defective components must be replaced.
Damaged valve guides or valve stems - Valves must be replaced.
Worn or stuck piston rings - Have piston rings replaced.
Scored piston or cylinder liner - Check liner and piston, change as required.
| Engine backfires |
Dirty fuel injectors - Service or change fuel injectors.
Dirty fuel lines - Fuel lines need to be cleaned.
Wrong ignition timing - Set the ignition timing properly.
Valve setting is improper - Set the valves correctly.
Air filter element is plugged - Service or replace air filter.
________________________________________________________________________________________
________________________________________________________________________________________
| Engines Technical Specifications |