________________________________________________________________________________________
| Home / Car Engines / BMW Engines / BMW M52B20 |
BMW M52B20 Troubleshooting
| Engine difficult to start or won't start |
No fuel in fuel tank - Fill fuel up.
Wrong fuel grade - Change fuel.
Dirt and debris in fuel system - Remove debris and dirt.
Disconnected or loose spark plug wire - Check the spark plug wire connection, repair or replace.
Spark plug is damaged - Spark plug need to be replaced.
Ignition failure - Check ignition system and replace faulty parts.
Fuel filter is plugged - Install new filter.
Dirty fuel lines - Clean fuel lines.
Clogged or defective fuel pump - Check fuel pump and change if required.
Dirty or damaged fuel injectors - Clean or install new fuel injectors.
Engine has bad compression - Check cylinder block and change wear parts.
| Rough engine running |
Ignition system malfunction - Check ignition and replace faulty components.
Air filter is dirty - Replace or clean air filter.
Spark plug is faulty - Change spark plug as required.
Fuel pump is faulty or clogged - Check fuel pump and change if required.
Improper valve clearance - Check and adjust.
Ignition timing is wrong - Set the ignition timing correctly.
Low idle speed adjustment is incorrect - Need to adjust idle speed.
| Engine starts and stalls immediately |
Spark plug is defective - Change spark plug.
Fuel injectors are dirty or defective - Test fuel injectors and replace if necessary.
Faulty ignition coil - Install a new ignition coil.
Loose or worn valve springs - Install new valve springs.
Valves sticking - Service the valves.
| Engine overheated |
Not enough engine oil - Need to add engine oil.
Engine overload - Load reducing required.
Fuel injectors are dirty - Clean or change fuel injectors.
Ignition timing is improper - Adjust ignition timing as required.
Valve setting is incorrect - Adjust valves correctly.
Damaged radiator cap or dirty radiator core - Replace cap or clean radiator.
Engine coolant is insufficient - Add coolant and check the components of cooling system.
Faulty thermostat - Thermostat need to be replaced.
Water pump failure - Change water pump as required.
| Abnormal engine noise or knocking |
Stale gasoline - Use correct fuel.
Engine is running overloaded - Reduce the load.
Engine oil level is low - Checking oil level and add if necessary.
Low idle speed setting is incorrect - Correct idle settings.
Fuel pump is clogged or faulty - Inspect fuel pump and change as required.
Main bearings or crankshaft are worn out - Need to install new components.
Valve clearance is wrong - Check and adjust.
Piston rings or cylinder bore are damaged - Replace faulty components.
| Engine power is insufficient |
Dirty or defective fuel injectors - Clean or install new fuel injectors.
Air filter is blocked - Clean or change air filter.
Clogged or defective fuel pump - Service or replace fuel pump.
Ignition system problems - Test ignition and replace failed parts.
Defective cylinder head gasket - Install new head gasket.
Burned or stuck valves - Change or clean valves.
Cylinder block parts are damaged - Replace defective components as required.
Plugged oil filter - Replace or service oil filter.
| High fuel consumption |
Plugged air filter - Change or service air filter.
Fuel injectors are damaged or dirty - Clean or install new fuel injectors.
Spark plug is faulty or loose - Change or re-tighten spark plug.
Bad ignition timing - Set the ignition timing properly.
Valves are stuck, worn, or burned - Clean or change valves.
Worn sleeve, rings, or piston - Change faulty components.
Valve clearance is improper - Check and adjust.
Poor compression - Inspect and replace wear parts.
| Engine oil consumption is too high |
Damaged gaskets or seals - Defective components must be replaced.
Valve stems or guides are damaged - Replace defective valves.
Stuck or worn piston rings - Change piston rings.
Scuffed cylinder liner or piston - Check piston and liner, change as required.
| Engine backfires |
Dirty fuel injectors - Service or replace fuel injectors.
Fuel lines clogging - Service fuel lines.
Ignition timing is incorrect - Set the ignition timing correctly.
Valve setting is wrong - Set the valves properly.
Air filter is dirty - Replace or service air filter.
________________________________________________________________________________________
________________________________________________________________________________________
| Engines Technical Specifications |