________________________________________________________________________________________
| Home / Car Engines / BMW Engines / BMW M52B28 |
BMW M52B28 Troubleshooting
| Engine doesn't start or starts hard |
Fuel tank is empty - Fill it up.
Incorrect fuel grade - Change fuel.
Water or air in fuel system - Remove air or water from system.
Spark plug wire is disconnected or loose - Check spark plug wiring connection, repair or change.
Spark plug is damaged - Replace spark plug.
Defective ignition - Inspect ignition system and change failed components.
Fuel filter is dirty - Fuel filter needs to be replaced.
Dirt in the fuel lines - Service fuel lines.
Fuel pump is damaged or dirty - Clean or change fuel pump.
Fuel injectors are clogged or faulty - Clean or install new fuel injectors.
Engine has low compression - Check cylinder block and replace defective parts.
| Engine runs intermittently |
Defective ignition system - Check ignition system and replace faulty parts.
Air filter is dirty - Change or service air filter.
Defective spark plug - Change spark plug as required.
Fuel pump is defective or dirty - Service or change fuel pump.
Valve clearance is improper - Adjust to proper valve clearance.
Wrong ignition timing - Adjust ignition timing as required.
Incorrect low idle setting - Need to adjust idle speed.
| Engine starts and stops |
Defective spark plug - Change spark plug as required.
Clogged or damaged fuel injectors - Clean or replace fuel injectors.
Ignition coil is damaged - Ignition coil should be replaced.
Broken or bad valve springs - New valve springs need to be installed.
Valves are stuck - Valves must be cleaned.
| Engine overheats |
Engine oil level low - Check and refill engine oil.
Engine is running overloaded - Reduce load.
Fuel injectors are clogged - Need to clean fuel injectors.
Ignition timing is incorrect - Set the ignition timing properly.
Incorrect valve setting - Valves needs to be adjusted properly.
Clogged radiator fins or leaking radiator cap - Replace cap or clean radiator.
Lack of engine coolant - Top up coolant fluid and check system for leaks.
Faulty thermostat - Change thermostat as required.
Water pump failure - Change water pump as required.
| Engine knocking sound or abnormal noise |
Stale gasoline - Use proper gasoline.
Engine is running overloaded - Load reducing is recommended.
Engine oil level low - Fill up the oil to required level.
Improperly adjusted low idle speed - Correct idle settings.
Clogged or damaged fuel pump - Inspect fuel pump and change as required.
Worn crankshaft or main bearings - Have bearings or crankshaft replaced.
Valve clearance is wrong - Check and adjust.
Damaged piston rings or cylinder bore - Replace defective components.
| Lack of engine power |
Fuel injectors are faulty or clogged - Service or change fuel injectors.
Air filter is dirty - Change or service air filter.
Fuel pump is damaged or dirty - Service or change fuel pump.
Ignition system is defective - Inspect ignition system and change faulty parts.
Worn cylinder head gasket - Replace cylinder head gasket.
Valves are stuck or burned - Replace or service valves.
Damaged cylinder block components - Change defective components.
Plugged oil filter - Change or clean oil filter.
| High fuel consumption |
Plugged air filter - Service or change air filter.
Fuel injectors are clogged or faulty - Clean or replace fuel injectors.
Faulty or loose spark plug - Tighten or replace spark plug.
Wrong ignition timing - Ignition timing needs to be set properly.
Burned, worn, or stuck valves - Clean or replace valves.
Worn piston, rings, or sleeve - Change defective components.
Valve clearance is not correct - Adjust to proper valve clearance.
Low compression - Check and replace worn parts.
| Engine oil consumption is too high |
Gaskets or seals may be damaged - New components need to be installed.
Worn valve guides and valve stems - Need to replace the valves.
Worn or broken piston rings - Piston rings replacement required.
Piston or cylinder liner is damaged - Inspect piston and liner, replace as required.
| Engine backfires |
Fuel injectors are clogged - Test fuel injectors and service if necessary.
Dirt in the fuel lines - Service fuel lines.
Improper ignition timing - Adjust ignition timing as required.
Valve setting is incorrect - Set the valves properly.
Air filter element is clogged - Service or replace air filter.
________________________________________________________________________________________
________________________________________________________________________________________
| Engines Technical Specifications |