________________________________________________________________________________________
Home / Car Engines / Nissan Engines / Nissan HR10DE |
Nissan HR10DE Troubleshooting
Engine difficult to start or doesn't start |
Gas tank is empty - Fill gasoline up.
Low-quality gasoline - Use quality fuel.
Dirty fuel system - Check and clean.
Spark plug wire is disconnected or loose - Inspect spark plug wiring connection, change or repair.
Defective spark plug - Change spark plug.
Ignition system malfunction - Check ignition system and replace faulty parts.
Plugged fuel filter - Fuel filter needs changing.
Dirty fuel lines - Clean fuel lines.
Fuel pump is damaged or dirty - Check fuel pump and change if required.
Fuel injectors are clogged or faulty - Clean or install new fuel injectors.
Engine has bad compression - Check cylinder block and change wear parts.
Irregular engine running |
Ignition system failure - Inspect ignition system and change failed components.
Clogged air filter - Replace or clean air filter.
Faulty spark plug - Change spark plug.
Fuel pump is clogged or faulty - Check fuel pump and change if required.
Excessive valve clearance - Adjust valve clearance.
Improper ignition timing - Ignition timing needs to be adjusted correctly.
Wrong adjustment of low idle speed - Correct idle settings.
Engine starts and stops |
Defective spark plug - Replace spark plug.
Dirty or damaged fuel injectors - Service or change fuel injectors.
Faulty ignition coil - Replace ignition coil as necessary.
Loose or broken valve springs - Replace valve springs.
Valves sticking - Valves need to be cleaned.
Engine overheated |
Low engine oil level - Check and refill engine oil.
Engine is running overloaded - Reduce the load.
Clogged fuel injectors - Test fuel injectors and clean if necessary.
Ignition timing is improper - Set the ignition timing properly.
Wrong valve setting - Adjust valves correctly.
Defective radiator cap or clogged radiator core - Clean radiator or change cap.
Not enough coolant - Add coolant fluid to cooling system and also check it for leaks.
Defective thermostat - Change thermostat as required.
Damaged water pump - Change water pump as required.
Abnormal engine noise or knocking |
Stale or low octane fuel - Use correct fuel.
Engine is overloaded - Reduce the load.
Low engine oil level - Need to add engine oil.
Improperly adjusted low idle speed - Need to adjust idle speed.
Dirty or defective fuel pump - Clean or change fuel pump.
Crankshaft or main bearings wear - Worn parts replacement required.
Excessive valve clearance - Adjust valve clearance.
Worn piston rings or cylinder bore - Change defective parts.
Engine power loss |
Fuel injectors are dirty or defective - Clean or change fuel injectors.
Clogged air filter - Change or clean air filter.
Fuel pump is defective or dirty - Inspect fuel pump and change as required.
Ignition failure - Test ignition and replace failed parts.
Cylinder head gasket is defective - Replace the gasket as required.
Valves are burned or stuck - Change or clean valves.
Cylinder block components are worn - Change defective parts.
Plugged oil filter - Change or service oil filter.
Engine using too much gasoline |
Air filter is dirty - Change or clean air filter.
Dirty or faulty fuel injectors - Service or replace fuel injectors.
Loose or faulty spark plug - Re-tighten or replace spark plug.
Ignition timing is improper - Adjust ignition timing as required.
Valves are stuck, worn, or burned - Service or change valves.
Worn piston, rings, or sleeve - Replace faulty components as required.
Excessive valve clearance - Adjust valve clearance according to specifications.
Poor compression - Inspect and replace wear parts.
Engine consuming too much oil |
Gaskets or seals are excessively worn - Change worn parts according to specifications.
Valve guides and stems are worn - Valves must be replaced.
Piston rings are stuck or broken - Piston rings need to be replaced.
Piston or cylinder liner is scored - Check piston and liner, change as required.
Engine backfires |
Fuel injectors are dirty - Service or change fuel injectors.
Dirt in the fuel lines - Clean fuel system lines.
Improper ignition timing - Adjust ignition timing correctly.
Wrong valve setting - Valves needs to be adjusted properly.
Dirty air filter element - Service or replace air filter.
________________________________________________________________________________________
________________________________________________________________________________________
Engines Technical Specifications |