________________________________________________________________________________________
| Home / Car Engines / Toyota Engines / Toyota 1HZ |
Toyota 1HZ Troubleshooting
| Engine difficult to start or doesn't start |
Clogged fuel filter - Replace the filter element.
Air in the fuel lines - Bleed the fuel lines.
Defective injection nozzle - Clean or replace injection nozzles.
Fuel injection pump is not operating properly - Rebuild or replace pump.
Valve timing is incorrect - Adjust or change timing gear.
Restricted fuel pipes - Clean or replace fuel pipes.
Injection timing is improper - Use correct injection timing adjustment.
Worn cylinder or piston rings - Change faulty components.
| Engine starts but stops suddenly |
Dirty fuel filter - Install new filter element.
Fuel injection pump is not working correctly - Replacement or repair required.
Dirty air filter - Change air filter element.
Unadjusted nozzle opening pressure - Set up as recommended.
| Engine shuts off suddenly while running |
Fuel injection timing is wrong - Set up as recommended.
Fuel filter plugged - Clean the filter or install new filter element.
Engine is not fully warmed up - Warm up to required temperature.
Defective or stuck injection nozzles - Service or change injection nozzles.
| Engine stalls at idle |
Incorrect low idle setting - Need to adjust idle speed.
The valve clearance is incorrect - Adjust valve clearance according to specifications.
Fuel injection pump damage - Change or repair the pump.
| Engine power is too low |
Fuel injection nozzles fault - Install a new kit of correctly balanced nozzles.
Fuel lines or hoses are clogged - Clean fuel hoses and lines.
Air cleaner is dirty - Air filter maintenance required.
Damaged cylinder-head gasket - Gasket should be replaced.
Wrong injection timing - Adjust according to specifications.
Faulty fuel injection pump - Install a new fuel pump or repair.
One of moving engine components has failed - Replace or repair damaged components.
| Engine is overheated |
Dirty radiator core or defective radiator cap - Clean radiator or change cap.
Low coolant level - The cooling system needs to be refilled and checked for faults.
Excessive wear of the fan belt - Change as required.
Engine oil level is insufficient - Checking oil level and add if necessary.
Cylinder head gasket defective - Cylinder-head gasket replacement required.
Unadjusted injection timing - Adjust according to specifications.
| Oil pressure is insufficient |
Oil level is low - Check and refill the oil.
Defective oil pump - Replace as required.
Dirty oil filter - Service or change engine oil filter element.
Stuck or defective relief valve - Replace or service relief valve.
Excessive oil clearance of crankshaft bearing - Test and replace or repair worn components.
Excessive oil clearance of crankpin bearing - Test and repair or replace worn parts.
| Excessive oil consumption |
Oil leakage: Damaged gaskets or seals - Change to repair leaks.
Oil viscosity is wrong - Use proper viscosity oil.
Piston rings are defective or worn - Piston rings replacement required.
Damaged valve guides or valve stems - Replace the valves.
Scuffed cylinder liners or pistons - Inspect pistons and liners, fit new components as necessary.
| Abnormal engine noise or knocking |
Engine is not fully warmed up - Engine is not warmed up to the required temperature.
Low engine oil level - Fill up the oil to required level.
Fuel injection pump timing is wrong - Check the fuel injection pump timing adjustment.
Pistons are scored or worn - Replace the pistons as required.
Connecting rod failure or misalignment - Connecting rod needs to be aligned or changed.
| Starter turns slow |
Low battery power - Battery needs to be recharged.
Battery discharges quickly - Battery needs service or replacement.
Battery terminals are corroded or wires are disconnected - Connect cables properly or replace terminals.
| Starter will not crank |
Battery is low or faulty - Replace or charge as required.
Disconnected or improperly connected wiring harness - Inspect battery wiring harness and connect as required.
Low battery output - Charge the battery.
Damaged starter motor - Change or repair starter.
________________________________________________________________________________________
________________________________________________________________________________________
| Engines Technical Specifications |