________________________________________________________________________________________
| Home / Car Engines / Toyota Engines / Toyota 2ZR-FE |
Toyota 2ZR-FE Troubleshooting
| Engine starts up hard or will not start |
No gasoline in tank - Add fuel.
Improper fuel grade - Use quality gasoline.
Air in fuel system - Bleed fuel system.
Damaged spark plug wiring connection - Inspect spark plug wiring connection, change or repair.
Spark plug is damaged - Change spark plug.
Defective ignition - Inspect ignition system and change faulty parts.
Fuel filter is dirty - Replace fuel filter.
Restricted fuel lines - Service fuel lines.
Dirty or damaged fuel pump - Clean or install new fuel pump.
Fuel injectors are defective or dirty - Inspect fuel injectors and change as required.
Weak cylinder compression - Inspect cylinder block and change worn parts.
| Engine runs intermittently |
Ignition system failure - Inspect ignition system and change failed components.
Air filter element is plugged - Clean or replace air filter.
Faulty spark plug - Spark plug need to be replaced.
Fuel pump is dirty or defective - Clean or change fuel pump.
Valve clearance is improper - Adjustment procedure required.
Ignition timing is improper - Ignition timing needs to be set properly.
Too low idle RPM - Test and adjust.
| Engine starts but stalls suddenly |
Spark plug is faulty - Change spark plug as required.
Dirty or damaged fuel injectors - Service or change fuel injectors.
Ignition coil is defective - Ignition coil must be replaced.
Loose or worn valve springs - Valve springs need to be changed.
Valves sticking - Valves need to be cleaned.
| Engine keeps overheating |
Engine oil insufficient - Fill the crankcase with engine oil.
Engine is overloaded - Reduce load.
Clogged fuel injectors - Test fuel injectors and clean if necessary.
Incorrect ignition timing - Ignition timing needs to be set properly.
Improper valve setting - Adjust valves correctly.
Defective radiator cap or clogged radiator core - Install new cap or clean radiator.
Lack of coolant in cooling system - Add coolant fluid and inspect the cooling system for leaks.
Thermostat is defective - Change thermostat as required.
Damaged water pump - Change water pump.
| Engine knocks or noises |
Stale fuel - Use proper fuel.
Engine is overloaded - Reduce the load.
Engine oil insufficient - Check and refill engine oil.
Improperly adjusted low idle speed - Correct idle settings.
Dirty or defective fuel pump - Clean or change fuel pump.
Crankshaft or main bearings failure - Have bearings or crankshaft replaced.
Incorrect valve clearance - Adjust valve clearance according to specifications.
Worn piston rings or cylinder bore - Replace defective components.
| Engine power loss |
Fuel injectors are defective or dirty - Clean or replace fuel injectors.
Plugged air filter - Replace or service air filter.
Clogged or defective fuel pump - Clean or change fuel pump.
Ignition system malfunction - Inspect ignition system and change faulty parts.
Defective cylinder head gasket - Replace the head gasket.
Valves are burned or stuck - Clean or change valves.
Faulty cylinder block parts - Replace defective parts as required.
Oil filter is dirty - Change or clean oil filter.
| Engine uses too much fuel |
Air filter element is plugged - Replace or service air filter.
Dirty or faulty fuel injectors - Inspect fuel injectors and change as required.
Faulty or loose spark plug - Replace or tighten spark plug.
Bad ignition timing - Ignition timing needs to be set properly.
Valves are stuck, burned, or worn - Clean or change valves.
Worn rings, piston, or sleeve - Replace defective components.
Valve clearance is not correct - Check and adjust.
Low engine compression - Inspect cylinder block and change defective components.
| Engine oil consumption is too high |
Worn seals or gaskets - Defective components must be replaced.
Damaged valve guides or valve stems - Install new valves.
Piston rings are seized or worn - Change the piston rings as required.
Piston or cylinder liner is worn - Inspect liner and piston, replace as necessary.
| Engine backfires |
Fuel injectors are clogged - Test fuel injectors and service if necessary.
Fuel lines are clogged - Service fuel lines.
Incorrect ignition timing - Adjust ignition timing as required.
Incorrect valve setting - Adjust valves correctly.
Air filter is dirty - Service or replace air filter.
________________________________________________________________________________________
________________________________________________________________________________________
| Engines Technical Specifications |