________________________________________________________________________________________
| Home / Car Engines / Toyota Engines / Toyota 3RZ-FE |
Toyota 3RZ-FE Troubleshooting
| Engine hard to start or will not start |
Fuel tank is empty - Fill gasoline up.
Improper fuel grade - Use quality gasoline.
Air in fuel system - Bleed fuel system.
Damaged spark plug wiring connection - Inspect the spark plug wire connection, replace or repair.
Spark plug is faulty - Spark plug need to be replaced.
Ignition system is defective - Check ignition and replace faulty components.
Dirty fuel filter - Change fuel filter.
Fuel lines are dirty - Clean fuel system lines.
Dirty or faulty fuel pump - Test fuel pump and replace if necessary.
Fuel injectors are damaged or dirty - Inspect fuel injectors and change as required.
Low engine compression - Inspect cylinder block and change defective components.
| Irregular engine running |
Ignition system failure - Check ignition system and replace faulty parts.
Air filter element is plugged - Service or change air filter.
Faulty spark plug - Install new spark plug.
Fuel pump is faulty or clogged - Clean or change fuel pump.
Improper valve clearance - Adjust valve clearance.
Incorrect ignition timing - Set the ignition timing properly.
Incorrect low idle setting - Adjustment required.
| Engine starts and stalls immediately |
Faulty spark plug - Change spark plug.
Dirty or defective fuel injectors - Clean or install new fuel injectors.
Faulty ignition coil - Install a new ignition coil.
Bad or broken valve springs - Change valve springs.
Valves sticking - Service the valves.
| Engine keeps overheating |
Engine oil level is low - Check oil level and add oil as required.
Engine is overloaded - Load reducing is recommended.
Fuel injectors are dirty - Test fuel injectors and service if necessary.
Incorrect ignition timing - Set the ignition timing correctly.
Valve setting is improper - Adjust valves correctly.
Dirty radiator fins or defective radiator cap - Clean radiator or replace cap.
Coolant level is low - Add coolant fluid and inspect the cooling system for leaks.
Defective thermostat - Install new thermostat.
Water pump malfunction - Change water pump as required.
| Engine noises or knocks |
Stale or low octane fuel - Change gasoline.
Engine is running overloaded - Reduce engine load.
Engine oil level is low - Add oil to the engine crankcase.
Low idle speed set incorrectly - Correct idle adjustment.
Fuel pump is dirty or defective - Service or replace fuel pump.
Crankshaft or main bearings wear - Install new parts as as required.
Valve clearance is wrong - Adjust valve clearance.
Cylinder bore or piston rings are worn - Replace defective components.
| Engine power is too low |
Fuel injectors are dirty or defective - Service or replace fuel injectors.
Air filter element is plugged - Service or change air filter.
Fuel pump is dirty or defective - Clean or replace fuel pump.
Defective ignition - Test ignition and replace failed parts.
Damaged cylinder-head gasket - Change cylinder head gasket.
Burned or stuck valves - Change or service valves.
Cylinder block components are damaged - Replace defective parts.
Oil filter is dirty - Clean or change oil filter.
| Excessive fuel consumption |
Plugged air filter - Service or change air filter.
Fuel injectors are defective or dirty - Service or replace fuel injectors.
Spark plug is loose or faulty - Re-tighten or replace spark plug.
Bad ignition timing - Set the ignition timing properly.
Valves are worn, burned or stuck - Change or service valves.
Piston, sleeve, or rings are damaged - Change defective parts.
Improper valve clearance - Adjust to proper valve clearance.
Poor engine compression - Check cylinder block and replace damaged components.
| High oil consumption |
Damaged seals or gaskets - Change worn parts according to specifications.
Valve stems and guides are worn - Install new valves.
Piston rings are stuck or broken - Replace piston rings.
Piston or cylinder liner is scored - Inspect piston and liner, replace as required.
| Engine backfires |
Clogged fuel injectors - Test fuel injectors and clean if necessary.
Fuel lines are dirty - Clean fuel system lines.
Ignition timing is wrong - Adjust ignition timing correctly.
Incorrect valve setting - Adjust valves correctly.
Clogged air filter - Replace or clean air filter.
________________________________________________________________________________________
________________________________________________________________________________________
| Engines Technical Specifications |