________________________________________________________________________________________
| Home / Car Engines / Toyota Engines / Toyota 1MZ-FE |
Toyota 1MZ-FE Troubleshooting
| Engine difficult to start or doesn't start |
Empty gas tank - Add gasoline.
Low-quality gasoline - Change gasoline.
There is air in the fuel system - Bleed the system.
Damaged spark plug wiring connection - Check the spark plug wire connection, repair or replace.
Spark plug is defective - Change spark plug.
Ignition system failure - Check ignition system and replace faulty parts.
Fuel filter is clogged - Change fuel filter.
Clogged fuel lines - Fuel lines need to be cleaned.
Fuel pump is defective or dirty - Inspect fuel pump and change as required.
Clogged or defective fuel injectors - Check fuel injectors and change if required.
Bad compression - Check and change damaged parts.
| Irregular engine running |
Ignition system is defective - Check ignition and replace faulty components.
Dirty air filter element - Clean or change air filter.
Defective spark plug - Change spark plug as required.
Dirty or faulty fuel pump - Inspect fuel pump and change as required.
Excessive valve clearance - Need to adjust valve clearance.
Bad ignition timing - Set the ignition timing properly.
Too low idle RPM - Adjust as required.
| Engine stops after starting |
Spark plug is defective - Spark plug need to be replaced.
Clogged or damaged fuel injectors - Check fuel injectors and change if required.
Damaged ignition coil - Install a new ignition coil.
Valve springs are worn or loose - Valve springs need to be changed.
Valves sticking - Clean the valves.
| Engine overheating |
Engine oil level is low - Fill the crankcase with engine oil.
Engine overload - Load reducing is recommended.
Dirty fuel injectors - Check fuel injectors and clean if necessary.
Bad ignition timing - Adjust ignition timing as required.
Valve setting is improper - Set the valves properly.
Clogged radiator fins or leaking radiator cap - Clean radiator or replace cap.
Engine coolant is insufficient - Add coolant fluid and inspect the cooling system for leaks.
Faulty thermostat - Install new thermostat.
Water pump failure - Water pump need to be replaced.
| Engine noise or knocking |
Stale gasoline - Change fuel.
Engine overloaded - Reduce engine load.
Lack of engine oil - Fill up the oil to required level.
Low idle speed set incorrectly - Test and adjust.
Fuel pump is damaged or dirty - Test fuel pump and change if necessary.
Main bearings or crankshaft failure - Repair or replace defective parts.
Valve clearance is not correct - Check and adjust.
Piston rings or cylinder bore are damaged - Change faulty components.
| Engine power loss |
Dirty or faulty fuel injectors - Test fuel injectors and change if necessary.
Air filter element is clogged - Replace or clean air filter.
Fuel pump is faulty or clogged - Service or change fuel pump.
Defective ignition system - Inspect ignition system and change failed components.
Cylinder head gasket is defective - Replace cylinder head gasket.
Valves are burned or stuck - Service or change valves.
Cylinder block components are worn - Replace defective components as required.
Plugged oil filter - Replace or service oil filter.
| High fuel consumption |
Dirty air filter element - Change or clean air filter.
Fuel injectors are damaged or dirty - Inspect fuel injectors and change as required.
Spark plug is faulty or loose - Re-tighten or change the spark plug.
Ignition timing is wrong - Set the ignition timing properly.
Stuck, burned, or worn valves - Replace or service valves.
Sleeve, rings, or piston are damaged - Replace defective components.
Excessive valve clearance - Adjustment procedure required.
Engine has bad compression - Check cylinder block and change wear parts.
| Excessive engine oil consumption |
Worn gaskets or seals - Install new components.
Damaged valve stems or valve guides - Change the valves.
Stuck or worn piston rings - Piston rings replacement required.
Cylinder liner or piston is scuffed - Check piston and liner, replace as required.
| Engine backfires |
Dirty fuel injectors - Service or change fuel injectors.
Restricted fuel lines - Clean fuel lines.
Ignition timing is wrong - Adjust ignition timing as required.
Valve setting is improper - Valves needs to be set correctly.
Air filter is blocked - Replace or service air filter.
________________________________________________________________________________________
________________________________________________________________________________________
| Engines Technical Specifications |